| Tower Model |
LUSO90US Self Supporting Crank-up Tower |
| Maximum Height |
92ft. / 28m |
| Minimum Height |
34ft. / 10.4m |
| Maximum Loaded Weight |
330lbs / 150kg standard
Option (440lbs / 200kg, 550lbs / 250kg, 660lbs / 300kg,770 lbs /350kg,
880lbs /400kg)
(max 2200lbs / 1000kg) |
| Wind load Capacity |
50MHP : 75sq.ft. at full extension ( 22 m/seconds : 7㎡ at full extension)
|
| Configuration |
Triangle |
| Structure |
Triangular truss
Monolithic structure by welding
Hot dip galvanizing |
| Width of top Section |
17inch / 442mm |
| Width of bottom Section |
47inch / 1176mm |
| Length of a Section /Number of Sections |
30ft. / 9m 4 Sections |
| Mast Bearing Stand |
Mast bearing stand on a top tower |
| Rotator Installation Stand |
9ft. / 2794mm below the top of tower |
| Intermediate Mast BearingStand |
6ft. / 1760 mm below the top of tower |
| Control Method |
Full automatic (with Indoor remote controller, without cable)
Inverter control
With soft start/soft stop function |
| Rise up and rise down Speed |
Approximately 1 minutes and 20 seconds |
| Winch |
Winch designed for LUSO90US exclusively
Chain drive method
Drum with grooves for wires |
| Electric Power for Winch |
Single phase 220 V |
| Motor Ratings Output |
1.5 kw |
| Motor Control |
Inverter control |
| Counter Balancer |
Using two units of balance weights
Elevator system |
| Guide Roller |
Guide Roller designed for LUSO Big series exclusively
Electroplating
Heavy duty bearings |
| Pulley |
Pulley designed for LUSO Big series exclusively
Electroplating
Heavy duty-sized bearing |
| Wire |
Steel wire with high bending resistance / flexibility
Wire diameter: 8 mm～11mm
Many flexible steel wires for each side of the tower unit
|
| Method for Detecting Top and Bottom Position |
Rotary limit switch designed for LUSO Big series exclusively |
| Total Weight |
9133lbs / 4110kg |
| Weight of Base Unit |
550lbs / 250kg |
| Length of Basic Unit |
7ft. / 2000mm |
| Safety Fence at low part of a Bottom Section |
Three-sided fence |
| Price |
US$20,000 |
