| Tower Model |
LUSO70US Self Supporting Crank-up Tower |
| Maximum Height |
72ft. / 22ｍ |
| Minimum Height |
33ft. / 10.1ｍ |
| Maximum Loaded Weight |
330lbs / 150kg standard
Option (440lbs / 200kg, 550lbs / 250kg, 660lbs / 300kg,770 lbs /350kg,
880lbs / 400kg)
(max 2200lbs / 1000kg) |
| Wind load Capacity |
50MHP : 75sq.ft. at full extension ( 22 m/seconds : 7㎡ at full extension) |
| Configuration |
Triangle |
| Structure |
Triangular truss
Monolithic structure by welding
Hot dip galvanizing |
| Width of top Section |
17inch / 442 mm |
| Width of bottom Section |
37inch / 916mm |
| Length of a Section /Number of Sections |
30ft. / 9m 3 Sections |
| Mast Bearing Stand |
Mast bearing stand on a top tower |
| Rotator Installation Stand |
9ft / 2794mm below the top of tower |
| Intermediate Mast Bearing Stand |
6ft. / 1760mm below the top of tower |
| Control Method |
Full automatic (with Indoor remote controller, without cable)Inverter control
With soft start/soft stop function |
| Rise up and rise down Speed |
Approximately 1 minute and 20 seconds |
| Winch |
Winch designed for LUSO70US exclusively
Chain drive method
Drum with grooves for wires |
| Electric Power for Winch |
Single phase 220 V |
| Motor Ratings Output |
0.75 kw |
| Motor Control |
Inverter control |
| Counter Balancer |
Using two units of balance weights |
| Elevator system |
| Guide Roller |
Guide Roller designed for LUSO Big series exclusively
Electroplating
Heavy duty bearings |
| Pulley |
Pulley designed for LUSO Big series exclusively
Electroplating
Heavy duty bearings |
| Wire |
Wire diameter: 6 mm～10mm
Many flexible steel wires for each side of the tower unit |
| Method for Detecting Top and Bottom Position |
Rotary limit switch designed for LUSO Big seriesexclusively |
| Total Weight |
4667lbs / 2100kg |
| Weight of Base Unit |
363lbs / 165kg |
| Length of Basic Unit |
7ft. / 2000mm |
| Safety Fence at low part of a Bottom Section |
Three-sided fence |
| Price |
US$10,000 |
